This form needs Javascript to display, which your browser doesn't support. Sign up here instead

Why use a transformer? And why Olsun transformers?

Example of a control system

Control system featuring an SCR power controller and an isolation type stepdown transformer

 

We’ve been asked why we control the power to molydisilicide heating elements using not only a phase angle fired SCR power controller, but also an isolation type stepdown transformer. After all, the SCR will do a good job of regulating the volts and amps required to fire the load, and the transformer is an added expense.

Here’s the reason: Molydisilicide heating elements have virtually no resistance on startup. So very low voltage and high amperage are required to fire the elements without blowing them away. This can be accomplished by using a soft start,  high amperage SCR, but then you must have greater line power amps. This can be a real problem in many laboratory settings where the available incoming power can be as low as 30 amps.

Consider an example. Suppose you have a benchtop furnace that uses six heating elements in series with a power requirement of 48 amps and a nine volt drop per element. Using only a power controller, the system will require 48 amps at the wall. But coupled with an isolation type (for safety) stepdown transformer, a 15 amp power controller can be used.

But what about the added cost of the transformer? This can be offset by the lower cost of the lower amperage power controller.

Why Olsun transformers? They design our custom transformers to meet ANSI/IEEE requirements including those outlined in C57.12.01 covering general dry type transformers. Therefore short term overload capacity is designed into every unit. They can deliver 200% of nameplate load for 30 minutes, 150% nameplate load for one hour, and 125% of nameplate load for four hours without being damaged. This is important to the efficient and safe operation of our control systems because molydisilicide heating elements have exponential resistance.

Learn more about Deltech control systems, ETL certified to conform to UL508A standards by Intertek.

medium voltage transformers, dry type transformer, transformer manufacturers, electrical transformers, low voltage power transformers, standard transformer

Leave a Reply

Your email address will not be published. Required fields are marked *

I accept the Privacy Policy

Covid- 19 Update: As a part of the critical manufacturing supply chain, Deltech Furnaces remains FULLY OPERATIONAL